Skip to content
Russellweb
2021 Jet comes back for some TLC

2021 Jet comes back for some TLC

8 November 2021


The owner of Jet had been in possesion of the car for a few years since I had last built it but hadn’t had a chance to drive the car much, or do any work and it was SRON’d. He reached out and asked if I would have a look at it and get it MOT’d. There wasn’t a rush so it was a nice eash side hobby for me.

Under Promise and Over Achieve

The short story is that I decided the naturally aspirated all steel block, was big heavy, asthamatic and good for 100hp if you’re lucky. I could get a 1.8 turbo engine (As used in the Audi A3 etc) and drop this straight in. I found an audi 1.8t from an Audi A4. In the A4 the engine is mounted longitudaly so inlet plenum is different to the A3 or TT; ideally it should fit easily. I’ll be honest here, I didn’t research much…

I Crossed my fingers and bought an engine on ebay; it did have the ECU and the loom with it, and delivery was on a pallet to my driveway. In the picture beneath you can see the naturally aspirated 5 cylinder in the foregorund and the new 1.8t in the background. Although gearboxes are interchangable, I used the spare gearbox from one of the donor cars I retrieved from France, as it was newer.

As you can see, the trial fit is perfect, loads of room, all I needed to make was apir fo engine mounts. The Edge has a 4 bolt plate on either side of the engine bay, allowing you to swap engines without modifying the chassis, just a new imtermediate bracket between the engine and the mounting plate is required. The turbo is clear of the chassis rail with plenty of room for the exhaust to come straight back, well away from the drive shaft, then drop down and out to the rear of the car.


The chassis is in oxide primer as well as I had decided to rough it back, inspect and repaint it; the chassis had been around for some time and with engines in and out I Was probably going to scratch the paint anwyay, so let’s tidy it up.



In the next article I’ll go into all the work I carried out to get this up and running, then MOT’s and off to the Silverstone F1 !

Until next time…