Skip to content
Russellweb
2022 Jet gets an MOT and goes on a roadtrip

2022 Jet gets an MOT and goes on a roadtrip

1 July 2022


As I mentioned in the previous post, the engine change looked good from a fit, and I hoped I could get the wiring and ME 7.5 Audi ECU working as expected. Teh A4 has a lot of bits I didn't need, but with a modern ECU it could throw all kinds of errors if things aren't setup the way the ECU expects. To fix theseI removed the immobiliser (I was running the origianl steergin column so that wasn pointless), second I removed the SAI (Secondry Air Injection); this is a whole bunch of pipework and stuff that just isn't required in this car. Associated with this was the servo take off, again I don't have one so blanked off, and finally I converted to use a carbon cannister and closed loop crankcase ventialtion system, although I had to be wary of the positive pressure the turbo would bring int; this would be trial and error. Final change would be the secondary lambda, downstream of the car, I Didn't have the room, and tbh with a wideband infront of the cat combined with a new cat which is readily visible in the engine bay I didn't need to have that. Some of these changes were interesting, especially having to open up the ecu and solder a grounding pin to enter config mode! At the end of all of this the engine ran perfectly, with no alerts to concern me. There were two alerts, but these were for not important. The first was the return coolant from the radiator as I wasn;t using the temp sensor for this pipe, the thermostat is ECU controlled anyway and the second error which was complaining about a lack of engine fan control unit had this covered with astandalone fan control, 2 stage, I had on the radiator.



Upgraded rear wishbones

With the newere ecu (Previusly I had the AUdi 2.3 engine which relied ont he K-Line) I now had a true canbus so I could talk to the ecu and integrate with it. Once the ECU was operating as expected I got it wired up, ran cleanly down the side of the chassis, and with the other cars, fitted the ECU inside the cockpit by the drivers elbow. The intercooler I decided could go behind my head rather than extra piping down into the side pod, I didn't want to delay the turbo spool by adding meters of pipe. With the gearbox swap I did need to have some driveshaft adapaters made up as the bolt pattern was close but not the same, this worked perfectly as I was also carrying out the lower wishbone upgrade Robin had designed for these cars.



Improved Fuel Tank top

The standard Edge setup is to use the Audi fuel guage and pickup, I didn't like it, so I made somethign I think look smuch better!


MOT Passed

There was an advisory on all four brake discs, they are a bit old, but the brakes, engine, chassis etc all went through without issue. I initally had forgotton to put the chassis plate back on the rear section of the chassis after painting it, so had to run home and get it! The MOT was one day before the weekend my brother and I had planned to go to the F1 in the two cars; passing really improved that weekends vibe :)


Silverstone F1

There isn't much to say other than it was a great weekend, and believe it or not we fitted all the camping gear, cooking stuff in the two kitcars, drove through fields, followed immensly long routes out of the camping ground without issue, and had a good cross country drive in both cars. Now as I had only just finished getting Jet back on the road, I let my nbrother dive Toto and I took Jet for her shakedown.