
2026 - Dashboard Ordered
5 November 2026
DIY or Do It Right
As you will probably have seen, I have spent a lot of time messing about with my own versions of CAN, paring this with the Emerald Ecu or on Jet the Audi ECU, then presenting this data onto a Nextion screen. Now the Nextion screens are super simple having only 4 wires, tx/rx/5v/gnd, and I just send, and optionally receive data form them., but they have one major downside; the screen is only about 350 nits. Now in most scenarios this isn’t an issue, but when you are putting this in as a dashboard on an opentop kit car, it is a very real concern. I need to see, amongst other things, how fast I am going; with the sun behind me or at an unfortunate angle, it is a very real possibility that I will not be able to read the dash.
Link to the dashboard: https://www.realtimedatamonitoring.com.au/products/rdm-7
So I have bitten the bullet and ordered a very good looking piece of kit that supports direct CAN connection and has a 1000nit display. I can’t tell you much more now, but the team there are super helpful, the information they have sent me, technically and from a setup persepctive is amazing and has set a new bench mark for me in customer service. ALthough I am not at SEMA I’m sure there is a lot similar to this, but this unit just feels right to me. My space is limited so I have gone with tthe 7”, I don’t need to wait on the 10” version.
When I get my hands on this I wil share some more insight, until then I will play with the Realtime Data Monitoring Studio and get everything ready!