Skip to content
Russellweb
2026 - Still tinkering.

2026 - Still tinkering.

1 November 2026


Dashboard and Canbus

Although the engine is good I Wanted to bring some improvements to Jet; the fuel level gauge wasn’t working, the dahsboard (Which had been pbased on an ipad) I decided needed an upgrade and a few other things.

Fuel Gauge

The fuel gauge was not looking right and when I pulled the sender out of the tank, the centre bolt had sheared/rusted and wasn’t working any more. I replaced this with a sealed cylinder style tube that uses a floating magnet to a multistage measurment inside the sealed tube. This gives 10 individual stages, enough granularity for the 33 litre tank. The other issue with cars like this is the length of the wire from sender to dash, so I developed by own CANBUS fuel level integration. This means there is a CANBUS device next to the tank, <20cm from teh sender and this measures the resistance and based on the shape of the tank (It’s trapezoid) calulates percentage in10 steps which is then transmitted in a single CAN packet at 2hz. Measurements are far more often and this is smoothed before being sent to the bus.

Dashboard

With the additional CAN traffic and the wish to step away from the iPad as dash I have switched over to NExtion for a display and an RP2350 running in Arduino IDE mode to operate it. When I managed to get this all working as expected, I started building a multipart dashbaord in FreeCad for my 3d Printer to make. I’m using PLA for test fits as I can recycle this easily, and then when finalised PET-G is used for the final product.

Seat

The seat I had in the car was originally as sepc’d by the owner, it was soft, padded and had an adjustible back…and also very large and heavy! I have rotated this out for a slimline fixed back bucket seat, although there is no room for me to put on any wait, or I will not fit!

Brakes

I had fitted Jet with a pair of brake master cylinders and a balance bar, it wasn’t goood, certainly not as good as Toto after her changes. I found an alternatvie tandam master cylinder and swapped this back in, it had a narrower bore and this has resulted in a much better feeling on the pedal.