Skip to content
Russellweb
2022 - An update on a few of the other devils.

2022 - An update on a few of the other devils.

2 December 2022


Where are the cars

There have been a number of cars purchased and I have been following as many of them as I can, the most I’ve had at any one time is still two, although I see that changing in the future!

On The Road

  • Toto - With me, active and alive
  • Jet - With me, active and alive
  • Buttercup - Sold, and sold again, then shipped back to the Netherlands where it is about to receive a new owner, and a paint job (See below)
  • Original V6 With Robin, built and so far as I am aware still with him
  • I5 Red car featured in the old Edge website - As far as I am aware, exported to Germany

  • In Build

  • The other V8 one - rehomed, engine changed to V6 and in build. (This is the image at the top of the page)
  • Other Red i5 car - In touch with the owner, build has stalled due to difficulty gettign inline 5 cylinders
  • One more chassis - I know where it is, when I find the room, I plan to build this, all of the details are yet to be decided!





  • Upgraded rear wishbones

    With the newere ecu (Previusly I had the AUdi 2.3 engine which relied ont he K-Line) I now had a true canbus so I could talk to the ecu and integrate with it. Once the ECU was operating as expected I got it wired up, ran cleanly down the side of the chassis, and with the other cars, fitted the ECU inside the cockpit by the drivers elbow. The intercooler I decided could go behind my head rather than extra piping down into the side pod, I didn't want to delay the turbo spool by adding meters of pipe. With the gearbox swap I did need to have some driveshaft adapaters made up as the bolt pattern was close but not the same, this worked perfectly as I was also carrying out the lower wishbone upgrade Robin had designed for these cars.



    Improved Fuel Tank top

    The standard Edge setup is to use the Audi fuel guage and pickup, I didn't like it, so I made somethign I think look smuch better!


    MOT Passed

    There was an advisory on all four brake discs, they are a bit old, but the brakes, engine, chassis etc all went through without issue. I initally had forgotton to put the chassis plate back on the rear section of the chassis after painting it, so had to run home and get it! The MOT was one day before the weekend my brother and I had planned to go to the F1 in the two cars; passing really improved that weekends vibe :)


    Silverstone F1

    There isn't much to say other than it was a great weekend, and believe it or not we fitted all the camping gear, cooking stuff in the two kitcars, drove through fields, followed immensly long routes out of the camping ground without issue, and had a good cross country drive in both cars. Now as I had only just finished getting Jet back on the road, I let my nbrother dive Toto and I took Jet for her shakedown.